What's new
VORON Design

Register a free account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members!

Recent content by Al555

  1. A

    Galileo2 Release

    Looking at a mjor update to my V2.4 R1. I would like to switch to umbilical and am considering the new Nitehawk system but wondering if it will support extruders like the G2? I'm thinking G2 + Stealthburner + Dragon Hotend + Nitehawk. Of course I will have to switch to a MGN12H too I expect...
  2. A

    Question The V0.1 page on GitHub only has a slicer profile for PrusaSlicer. Is there a profile for SuperSlicer or Cura anywhere?

    Ellis has some good profiles and keeps them up to date https://github.com/AndrewEllis93/Ellis-SuperSlicer-Profiles
  3. A

    Question Upgrade V2.4 to MGN12H or R2

    I have a V2.4 and am considering moving to the MGN12H in preparation for adding the Tap when it is released. I assume if I don't want to do a major rebuild to R2 I can simply change out the X rail mounts and add the new Linear rail? I'm also considering adding the StealthBurner with a Orbiter...
  4. A

    Troubleshooting frequent hotend clogs or extruder skipping

    Does the reverse Bowden run all the way from the toolhead to the spool? I have seen some builds where there is a short piece of tubing at the tool head and the filament is then bare until close to the exhaust vent where it enters another piece of tubing.
See more
Top