Register a free account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members!
Anyone considering a single horizontal cable chain from the printhead to the back or side wall? I've seen this somewhere and it appeared to be a compact elegant solution.
CAN is a good improvement. Saves tons of copper in cars. For reliability smaller, finer stranded wires are better. Multiple parallel wires for power and ground might be the way to go. The thin flat cables are good also, and again parallel paths are used to handle the current while providing high...
Prusa puts a piece of filament (Nylon?) into the MK3 umbilical to stiffen it, and minimizes connectors. It lasts quite well but is less fun to repair as the umbilical has to be reworked with each toolhead component replacement.
Thanks Nero, I started watching when you built the switchwire and have been watching most of the vids since. Quite a journey. Now building an LDO Trident and have many parts for other Vorons to build more. Mostly your fault. And Steve's. :)
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.