Recent content by Alofly

I have finally managed to finish printing a test frog in three colors. To do this, I had to disable the cameras and the LED animation of the SteathBunner. Now I need to look for alternatives to be able to monitor the printing...

More tests. On this occasion, I have detected that the Blobifier servo has malfunctioned again, blocking the Host when activated. I have replaced the servo and installed a new 5-volt power supply for the CB2. Result: MCU `mcu shutdown: Missed scheduling of next digital out event This is...

Hello again. I found a connector between the EBB and the Cartographer that might be causing problems. Everything has been working like clockwork. But after several hours of printing without any incidents, I am getting this error. This is really frustrating. Can not update MCU 'mcu' config as it...

Thank you very much for your response, I am trying some solutions from the links you mentioned. They seem more oriented towards the problems I have with the Trident. Since this one has the BTT PI V1.2 installed.

Yes, I realized my mistake. But I was hoping to find some help rather than a sarcastic comment. I've had to check the servo arm twice and the Filametrix blade once. If you're familiar with the ERCF, you'll know I've used kilograms of filament in many tests. I've encountered all sorts of...

Hi, I'm having a lot of trouble with my Voron 2.5 and the ERCF V2. I'm troubleshooting, but I don't know how to handle this error. MCU `EBBCan' shutdown: Missed scheduling cd next digit out event This is generally indicative of an it oermittent communication failure between nicro-controller and...