VORON Design
Register a free account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members!
Recent content by avnc
-
A
Layer shift along X and Y at third layer
If the layer shifts come back, check your A/B motor shaft grub screws! Had very similar and oddly intermittent issues due to that last year.- avnc
- Post #8
- Forum: General Voron Chat
-
A
Lost communication with MCU 'nhk
Could be voodoo, but my problem with these errors went from 2 or 3 a week to once in 3 months when I replaced SB door/hatch part with a vented version (this one https://www.printables.com/model/907170-voron-clockwork2-cable-cover-with-ventholes-for-ld ). I was printing a lot of ASA & ASA-CF so... -
A
Solved LDO V0.2-S1 Picobilical 5V stopping MCU from starting
This could be not enough juice from power supply. Zero2w, 3b and 4b have escalating power requirements (w/zero the least). Working with 3b when 4b didn’t could be the extra 0.5A needed. Add picobilical, skr, etc and the power needs add up…- avnc
- Post #15
- Forum: Voron Zero