Recent content by Azazel

My Voron Trident is running since begining of the week, working pretty well running octopus pro with BTT UC2 & EBB SB2009 (2040) over CAN. Printing fairly well, not 100% precise as minor artifacts can be found now and then on overhands or angles etc. but as long as the first layer gets down good...

No need i switched to using endstops and later i burnt the spider board and swapped to octopus board instead so i have progressed to new issues here and there but am mostly having everything working now.

Either it was always moving a bit and didn't stall when hitting a rail or it never moved att all even when getting to 0 from 255. But right now i picked up two micro switches i will try using for X & Y endstops to see if i can proceed like that - maybe i go back to attempt sensorless again later.

Well my issues have normaly been that either it moves a little and stopps each time all the way from 255 to 0, or it never moves. After my last time around, playing around with settings it started moving all the way to the rail and tries to continue - which makes it jump and bounce against the...

Hi all, I'm building a Voron Trident 350, and have been slowly assembling it over the past six months. At this point, I’ve wired up enough to start testing motion — but I’ve hit a wall right away with sensorless homing for X and Y (Z will eventually use Tap). Either the axes don’t move at all...