Recent content by Azertime

Thanx a lot ! I managed to get It working, Homed all axis and done a Z-tilt, But I am stuck again ... I tried following the Klicky-Probe Guide and installed all macros and stuff, added my z endstop pin location, and also the dock location, but now It won't home any saying "Macro G28 called...

fixed, it was my wiring some crimps had snapped thank you anyway for your help, I am starting to test homing now XY is ok but for Z it prints "Move out of range: 207.000 405.000 10.000 [0.000]" do you have any clue ?

Thank you for your reply, I'll check that and have a look at your config, also I initially didn't mention this but I am going for a klicky probe on my setup. Don't know If this has an influence for my problem or not but I guess not.

I tried different things, the motor front right motor which doesn't move is still humming slightly. I wonder if it has something to do with the motors winding.

Hi, I am building A self-sourced voron trident (400x400x500 build), with a BTT Octopus PRO v1.1. Everything is going great for now, toolhead is doing what it's supposed to etc. Only I am now configuring the 3 Z-Steppers and they are doing completely different things. front left is noisy and...