What's new
VORON Design

Register a free account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members!

Recent content by BaronWilhelm

  1. B

    CAN bus end stops

    Great writeup, I'm going to refer to that when I do mine for sure.
  2. B

    Question Months of rippling/VFA/ringing artifacts

    I went through some of this and can relate to some of your feelings. Stick to it, you'll get it and learn a lot along the way! I can't specifically say what cleared it up for me, but it was some convergence of print temp/speed/cooling, replacing CW2 with genuine BondTech gears, CW2 filament...
  3. B

    Oiled my rails (and swapped to a stealthburner) now my toolhead is dropping to the print bed when motors shut off

    I just watched a video on this Project R3D ZMotor brake board, might be of interest to you.
  4. B

    Mobileraker - Control Klipper via Phone

    I loved OctoPod for my Ender 3, I've definitely missed notifications since building my Voron. I hadn't learned about Mobileraker Companion until now, going to give it a try. Minor, but I also miss all the Estimate/Slicer timing info from the web dashboard. Great app, keep it up!
  5. B

    Troubleshooting probe accuracy and QGL "Samples Exceed Tolerance" issues on a V2.4

    This GitHub project, KiloQubit/probe_accuracy, was REALLY helpful for getting my "Samples Exceed Tolerance" issues resolved. It showed more variation in certain corners and I slightly tightened those Z belts. I was using KlickyNG and also had to fiddle with the probe's switch pins a bit to get...
See more
Top