VORON Design

Register a free account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members!

Recent content by BeerMedic522

  1. B

    V0.2 bed level

    I’m about done with this thing. Gone through the bed assembly 5 times. Run the paper test 20 times and nothing changes. Right side won’t stick and left side drags the bed. I even threw a level on the bed and it’s level. Gantry is square.
  2. B

    V0.2 bed level

    That’s what I have done. Just a bit of resistance at each screw. But then I print and all heck breaks loose….
  3. B

    V0.2 bed level

    I have it built and am trying to adjust the bed. I run the bed_screw_level macro and the print head goes to the three spots on the bed, I adjust the bed screws at each until the paper test is the same in all three. When I go to print though, the right side of the bed is further away ( filament...
  4. B

    My Voron 0.2

    anything new?? Looks great, looking to use some of your ideas in my V0.2
  5. B

    My Voron 0.2

    When do you think you'll have the hex files for the tophat available??
  6. B

    Question How to set up slicer

    Thanks, that helps.... some. So I overwrite what is in there with the new one from KAMP??
  7. B

    Question How to set up slicer

    I guess what I’m asking is where do I put the codes and macros for Voron Purge, etc? Does it go in the slicer custom gcode, my printer.cfg, a new .cfg that I need to [include] in my printer.cfg? I’m lost
  8. B

    Question How to set up slicer

    Can someone point a YT or GitHub that in plain English would show me how to edit the slicer settings, where to put the PRINT_START and END? I’m getting lost with all of the “lingo”.
Top