Recent content by Beez

As of today, they still seem to be missing from the build manuals. I was having some trouble with overextrusion and these would not go in, even with pliers. Extrusion multiplier calibrated with a few test prints and now they are perfect!

##################################################################### # LED Control ##################################################################### ## Chamber Lighting - HE2 Connector (Optional) [output_pin caselight] pin: PD15 pwm:true shutdown_value: 0 value:0.0 cycle_time: 0.01 I...

Yes that’s got to be it. I’m still not 100% confident hacking in the .cfg files. But I got most everything working. Still need the rgb LEDs in the stealth burner and the cpu fans aren’t working, but I’m making steady progess! Thanks for all the help so far! Did a bunch of dimensional checks...

Fourth try…

It got better with Z height recalibration. But still came unstuck after about eight or nine layers. I'll clean the bed with 99% ipa and have reset the first layer temp from 55c to 65c. Any advice for setting up for unattended operation? I'll need a camera, and a filament runout detector I...

Bottom left of the mainsail webpage? under misc? Nothing there. And the .config doesn't help. Added is that the lights seem to flicker when the heaters are working. Pretty annoying, but not top priority. Right now I'm having trouble getting the first layer to stick. PLA. Textured build...

Yep the 400 steps per rev seems to have fixed that issue…

Yep it was steps per rev. Now able to quad level, and extruding spaghetti! :p Here's a random question, anyone able to dim the lights in the enclosure? I've tried a few things, and can't get them to dim. May have to try inline resistor as it's only a few watts. I find the color temp very...

Got things homing, probing the bed (omron inductive) have parts for klicky but not installed. Noticing that X,Y scaling seems to be off. the home positions are set at 350,350 but 0,0 is approx the middle of the build plate. Should be the opposite corner methinks. Looking at printer.cfg there...

Ok, this is GREAT! Nothing is heating without command, I can set PLA heater settings and the bed and hot end come on as do the chamber LED strips, and temps go right to set points and stabilize. Hit the cooldown button and things are cooling down. chamber lights off. the lower fan on the...

ok, where's the facepalm emoji? Naturally it's 42! Thanks Sanity, you're helping maintain mine!

Thermistor type enumeration? Voron docs state: https://www.klipper3d.org/Config_Reference.html#common-thermistors but when I try: ## Check what thermistor type you have. See https://www.klipper3d.org/Config_Reference.html#common-thermistors for common thermistor types. ## Use "Generic 3950"...

yep working towards the MCU config now... Thanks all!

But there's this! :)

Thanks very much folks! was mostly offline the last couple days building and wiring a sauna for my GF. First heat was tonight! I'm digesting your advice and have flashed the pi firmware a bunch of times. Got it working at my GF's house and now mine. I can ping the raspberrypi.local, and ssh...