Recent content by blinkytheslayer

Okay, so I feel like this could be the issue. How much, or how easy should the side to side play be? I thought I had them setup as you described, loose enough to move side to side (in the x/y direction) but no vertical play (z direction). From your description here: "Tighten them until they are...

Yeah, wouldn't be my high percentage guess either. But like you said, trying to gather opinions and cover all my bases. I'd rather cross off a bad theory that leave the correct one of the list. Any bets on the other options? Easiest to check IMO are 2 and 5 so I'm going to reprint the z...

I contacted the seller where I bought the kit and they are going to send new pom nuts out, but was going to take a bit to arrive. I didn't want to wait that long so ordered some other replacements off of amazon. Replaced all 3, but the one nut is wearing again. I can see the pom plastic bits...

This just happened on my LDO Trident 300mm^3 I built last month. Barely 100 hours on it. worried it failing may have bent the lead screw. Contacted the seller and ordered some replacements from amazon. couldn't find any of the right sized ones on any of the Canadian 3d printer companies.