Recent content by Bluediablito

Thank you

Is there a way to have the lights turn on when the printer starts? If so how? I tried adding an initial number but nothing.

So even if I don't have a mechanical end stop, I would need to add "endstops: x, y, z" ? If I don't have a logo led at the moment, adding homing to the top should also be required right? Example [led_effect Caselights_homing] Thank you for sharing by the way.

How is the SB2240 board. I am thinking of upgrading my system to a can system and I was wondering if you are having any issues with the board?

Yes this is the base for my current file. I am trying to get tap and homing to show but I can't figure it out. Thank you.

Can you share how to make it work with tap? I have been trying but nothing at the moment. Thank you

Thank you all for the response. It worked on the same port with the diode. The only thing I need to do is invert the signal and everything is good to go. Thank you once again.

Does work if I have sensorless homing and Tap?

So based on the post the CNC tap sensor should be wired the same way it was wired for the omron inductive sensor with the Bat85 diode?

Hello all. Currently had an omron probe fail/burn on my voron 2.4 build. Decided to upgrade to chaoticlab CNC tap V2. At the moment I can't figure out how to wire/ connect the sensor of the CNC tap? The PDF talks about v5 and v24 Questions 1. Can someone share what pin should I connect the...