Recent content by Brawler215

Thanks! It was a bit of a needle in the haystack. One person on a reddit thread had mentioned that they had swapped their stepper drivers to TMC5160s to correct the problem, so I just decided to check into documentation on the 2209 to see what differences there were between the drivers. I just...

I found the answer to my issue. It seems that having interpolation on for the TMC2209 stepper drivers while using klipper can introduce a lag that creates a noticeable positional drift. The driver basically takes a bit too long to do the math for making an interpolation calc and klipper doesn't...

You're misunderstanding what's happening a bit. If I do a group of only 20 pieces, they come out fine (or at least with a skew so small that it I cannot perceive it). If I make batches of more parts, the skew worsens. The skew will affect all parts on the build plate equally; the only thing that...

Going off a recommendation from reddit, I ran my printer through Ellis' max speed and acceleration tuning guide: https://ellis3dp.com/Print-Tuning-Guide/articles/determining_max_speeds_accels.html The thing that was very interesting to me was that after running my toolhead at the travel speed...

If I print a single part that doesn't have a lot of travel moves (such as the voron cal cube) it turns out just fine. I also printed a 100mm skew calibration object and that was within a millimeter of being square at worst on every plane and axis, so the skew correction is very small. Last...

Thanks for the info. More often than not, it is something simple so it's good to check that first. I am pretty stumped. I tried cranking up the run current on the AB steppers from .8 to .9, but the skew persists if I try to print a batch of like 90 of those screws, but only 20 end up just...

Thanks for the reply! I have double checked the grub screws and they are tight and loctited properly into place. My belts are slightly tighter than recommended; they are buzzing at about 130Hz along a 6" section instead of 110Hz. During my initial assembly, I had followed the instructions to...

I have recently completed my Trident 300, and it has gone very well except for a very weird issue. I can print out an object like the Voron calibration cube perfectly fine, with everything square and no issues or artifacts. But, once I try to print anything that will introduce higher...