Recent content by Broken3Dprinter

My config file is straight off the BTT documentation "sample config file". I"m still not sure where to go from here.

My config for the fan looks like this: [fan] pin: EBBCan: PA1 [heater_fan hotend_fan] pin: EBBCan: PA0 heater: extruder heater_temp: 50.0 #[heater_fan 4W_FAN0] pin: EBBCan: PB14 tachometer_pin: EBBCan: PB15 tachometer_ppr: 1

Finally have the Canbus up and running (EBB SB2209/2240). The one thing that doesn't seem to work is the hotend fan. I double checked the crimps and the fan does function. Hot end heats, parts fan works. Is there anything else that I may have missed?

Hey, thanks. . .that worked!

EEEK, OK, here it is. As of yet, I haven't gotten this thing to work, still trying to get config to load. Thanks for your help. Joel

My search has come up empty and I'm running out of ideas. I keep getting an error: Option 'pwm' is not valid in section 'controller_fan controller_fan' My fan config is below. I'm running Klipper on Octopus with an EBB SB 2209/2240 Canbus. I have yet to get this working, still trying to get...

These were helpful, thank you. I have my canbus uuid. Unfortunately, now I can't determine my Octopus UUID or serial. I've tried hooking the pi up to only the octopus, but I can't get anything to show up with the ls /dev/serial/by-id/* command. pi@voron24:~/klipper $ ls /dev/serial/by-id/*...

Thanks for the information. Still not getting anywhere. It would be wonderful if someone had a Voron IT service where you could call and get all my questions asked. I did have the printer working briefly, but I wanted a different probe, and I figured while I was at it, I would go ahead with a...

Getting errors when I try to flash the bus after getting the id off of DFU mode. I have tried to install it before, but I couldn't get the MCU to show up to put the info in the config file. I get this error.: Flashing out/klipper.bin to 0483:df11 sudo dfu-util -d ,0483:df11 -R -a 0 -s...

Thanks for the info on this, after reading esoterical, I finally got my SB2209 to go to DFU mode. Additional question though: does it make any difference how you connect your U2c, RPi and Octopus? I'm guessing since they are connected by USB they should talk to each other, or am I not...

Thanks! Low profile with the Stealthburner? Is the an adapter you have to print?

I couldn't get anything to work, so I removed and reinstalled everything. Seems to "work" now, but my homing is inconsistent, so I'm going to a manual z endstop.

I haven't been successful in using btt eddy as an endstop, so I'm going to the mechanical z endstop. Where in Klipper do I indicate the x y location of the probe? When I read the Voron documentation, it seems like it ought to be something I'm already aware of, but I'm not. Thanks

Brand new 2.4 build with a BTT Eddy probe. Everything sort of worked initially, but when I tried to redo the "paper test" the command won't bring up the adjustment screen. I don't seem to find this problem on the BTT site. Using the PROBE_EDDY_CURRENT_CALIBRATE_AUTO command. Any ideas?