VORON Design

Register a free account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members!

Recent content by BrokenPoet

  1. B

    Diagnosing random shutdowns of new Voron 2.4R2

    I installed a V2.1 U2C instead of using the Octopus for my CAN solution and it works as expected now, two long prints completed. (Still using the Octopus, just not the CAN Bridge.) Not sure if it was Klipper or some odd intermittent hardware failure, but I'm glad that it's working!
  2. B

    Diagnosing random shutdowns of new Voron 2.4R2

    I'm running at 500k with no dropped/delayed packets when things are running (until the loss of the CAN/USB link). Both the Octopus and EBB36 klipper firmware were set to 500k at build time. I swapped out the Orange Pi for a Raspberry Pi 3 with the same failure mode, continuing to troubleshoot...
  3. B

    Diagnosing random shutdowns of new Voron 2.4R2

    I am just finishing the build of my first Voron and have been trying to diagnose random shutdowns that predominantly occur during prints (I think I may have caught one that was not during a print as well.) My setup is as follows: Base Formbot kit Orange Pi 4 LTS (Running Armbian Jammy) Octopus...
Top