Recent content by cabinfourus

Just to update the information, I replaced the BAT85 diode just to rule out a bad diode. While double-checking my printer.cfg file, I found that my X axis required the ! Symbol next to the end stop pin number, and the Y axis did not need it. Both mechanical switches were wired the same, but...

I am finishing up my first Voron 2.4 build. While going through the initial startup, I noticed my hot end Neo pixels stopped working. I thought maybe the wiring had come loose or maybe a connector, but everything checked out okay. I went ahead with the start-up and when I came to the level...

First, I want to give a shout-out to the people who work hard to bring us the Voron projects. You guys are amazingly talented, and I am grateful that you share your talents with us all for FREE. My knowledge of 3D printing is limited, but growing daily. I have designed and build several of my...

Thank you for the information. I still have some time before I get to make a choice on the hot end, but I am close. With my build, I chose the 350mm size. I am off with some of my measurements, so I am going just a tad bigger. This has bee a GREAT winter project.

Hello everyone. The forums didn't seem to have a place for new members to introduce themselves, or in my ignorance, I couldn't find it. My apologies if this is located in the wrong section. One day, while doing some work at a wedding with my wife, I accidentally flew one of my drones into a...