Recent content by CallumRD1

I used this one: https://github.com/elcrni/Voron-Mods/tree/main/Orbiter_2.0_SB_CW2_Enclosed The tolerances on some of the holes seem slightly off, but nothing that a quick pass with a reamer couldn't fix. Other than that it's a really elegant mount, completely hiding the extruder and...

Just closing the loop on this issue: I went through the ClockWork2 extruder with a fine toothed comb, even checking each moving part with an indicator and didn't find any obvious sources of the issue. The plastic 50T gear had about 8 thou of axial runout in it, but that shouldn't have made much...

This is very useful, thank you. This is a new build, with only about 1.5 kg of filament run through it, so everything is clean and sharp. I'll take it back apart tomorrow and check for eccentricities. That sounds like the most likely source of my problems. I was careful it setting my backlash...

Yes, I'm well aware of that. I mentioned having skipping at 25 mm^3/s just to illustrate that I know what the skipping of the clockwork looks like when exceeding the hot-end's max flow rate. The print samples I'm testing and having issues with are from "80-250 mm/s velocity at 0.4mm layer width...

Hi all, I'm having an issue with periodic under extrusion and it's driving me nuts. I've attached a representative photo below. This issue occurs both on flats and on walls, with the under extruded parts causing structural failures in walls. This is Polymaker ASA, printed at 250˚C, 260˚C, or...