Recent content by cecilx22

So, just throught I'd post this as a warning. When you get creative and make your own parts, even if they aren't functional parts, be careful. I built a 2.4 over the summer, and have been having strange issues with bed probing, QGL, etc. Anything that involves moving the gantry up/down very...

Hello! I ordered a fystec sb_can_toolhead v1.3 from AliExpress, in part because it was less expensive, but also because it was pretty well documented. I RECIEVED a sb_combo_v2 board, which is a significant upgrade, however the documentation is still so new it's... ever changing. Anyhow, I'd...

Hello! I ordered a fystec sb_can_toolhead v1.3 from AliExpress, in part because it was less expensive, but also because it was pretty well documented. I RECIEVED a sb_combo_v2 board, which is a significant upgrade, however the documentation is still so new it's... ever changing. Anyhow, I'd...

Thanks for the reply! For (1), what file would I find that in? (related - is there some sort of documentation that I can refrence that would answer these sorts of questions more broadly?) As far as discarding samples - It appears to me that there is some systematic error in the system as a...

I'm having a very specific issue with the QGL and the inductive probe. During leveling, the first 1-2 samples are almost always lower than the next 4-5 samples. I see this a bit with bed mesh as well. Same with probe accuracy routine. I'm sure I could tear the whole machine apart and try and...

Thank you both! The history is actually super helpful! In my case, I'm going to leave it wired into the endstop for the moment (work is already done), but when I get around to rewiring I'll move it then. Thanks so much!

Doing a self sourced build, following the BOM and sourcing guides from the configurator. I have an octopus 1.1 board, and I'm seeing conflicting info on wether I need a diode or not. The build guide says a diode is for sure needed, but the octopus diagram in the same guide says it is not needed...