Recent content by coro

Ok, I quickly looked at the documentation, and I think I have a possible solution that could work for you. The EBB documentation specifies the correct pinout, and that's what you've added to your config. However, your config still needs to know how to interact with your new hardware. The...

It doesn't look right at all. I'll need to check the documentation to be sure. I'm using an EBB36, and maybe there's a difference in how the fans are configured. But regardless, your setup isn't clean. There are things like: kick_start_time cycle_time off_below It's not a good idea to copy...

Have you tried looking closer at the documentation. I think the hotend fans are a bit difficult to configure correctly. Mine works fine, but the logs keep giving error messages. The problem in my case will most likely be solved by improving and optimizing the fan configuration so that the canbus...

https://docs.ldomotors.com/voron/LDO_Voron_Distributors

Hey, I recently got a new printer and made a mistake. When I brought it home, I adjusted the belt tension screws, which I probably shouldn’t have done. Now, I’m trying to find a guide to get the printer running again and properly tuned. The printer was purchased pre-assembled from someone in...