What's new
VORON Design

Register a free account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members!

Recent content by cosminr86

  1. C

    Real 300mm in Z axis with direct extruder

    Or you can print a top hat and get a bit more room at the top
  2. C

    Relay heater safety

    I use a relays for years on my ender 3. Wired to mains, so no main power to 24v PSU. On my voron I used 2 relays, commanded by a single gpio pin from pi. One is turning off the mains to bed SSR and the other one the mains to the 24v PSU. I use mainsail to turn it on/off. I don't really care...
  3. C

    Question Inconsistent nozzle offset issue

    AFAIK is better to wired the probe to the endstop on the canbus toolhead, not to the probe pin. Endstop pin have "better" hardware. I use my canbus speed at 1.000.000. Make sure you preheat to the same chamber temperature. Auto Z helps. Thermal compensation may help. Titanium backers helps...
  4. C

    Stepper Motor Vibration at power on

    pins: PE9,PD9,PD15,PE5,PE3,PE8 With my mainboard the z steppers was powered at startup. If klipper was in an error state when the mainboard gets powered on, my z steppers was energised. I still got a small "kick in" when power on, but is fine. I use a relay to power 24v separately from...
  5. C

    Stepper Motor Vibration at power on

    It's not a configuration problem as is a low level settings that needed to be changed in make menuconfig before flashing
  6. C

    Stepper Motor Vibration at power on

    I have same problem with spider 3.0. The default enable pin must be inverted when you compile the firmware.
See more
Top