What's new
VORON Design

Register a free account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members!

Recent content by Crashdown

  1. C

    Is it normal for PT1000 to read slightly high at room temp?

    Mine reads about 2.5C above my other thermistors that all agree very closely. Its been working fine for me for hundreds of hours. I wish I could tell you something more definative but I think its just a feature of the SB2040
  2. C

    Question Most critical plastic part for quality prints?

    As has been said, if you used ABS+ material I would reprint the X carriage especially and most of the toolhead. At the very least so you have spares. With ABS+ the heatset inserts like to pull out from the carriage and extruder. That's where the most heat is and where ABS+ is not so great.
  3. C

    Question Voron 2.4 bad layers.

    Check the carriage is tight and not wobbling. Check any grub screws to make sure they are tight. I mean it doen't look that bad unless its worse in person. I had bad layers once that I eventually tracked down to a partial clog in the hotend. Not enough to jam the extruder, just like a coating...
See more
Top