Recent content by dafinch

Ok. after some poking around I found X and Y endstop configs in the default nitehawk-sb.cfg. This is probably something that should be discussed in the Nitehawk documentation as a note to disable this if you are wiring to the MCU or if you're using Sensorless Homing. There is a FAQ question on...

Looking for some help. I tried discord already but only one person was really helping and he kept saying that I had a config wrong, bad wiring, or bad switch. So I've been through all of that. Then only thing I can't rule out is a bad config but I've recompiled Klipper and rebuild the printer...

Maybe an unpopular opionion but, I find it disappointing that the LDO Nitehawk umbilical is not compatible with the Leviathan controller board. The Leviathan has a standard CANBUS connection. It would have been nice to also have a Nitehawk connection or perhaps an alternate Leviathan model...

Thanks for the feedback. That's what I was afraid of. I think I'll need to look at using two uhp supplies, 1 24v and 1 48v,

So my Fysetc Spider died and I'm replacing it with an LDO Leviathan. I've got the stock mean well LRS-200-24 but want to take advantage of the 48v drivers for AB motors? My AB Motors are Stepper Online 17HS19-2004S1 rated at 2amp max, Configured for 1.2 amp. What size PS would I need to cover...

Good, question and is interesting that it came up now, for me at least. I'm just starting the sourcing for a Switchwire and wanted to do this also. I'll be researching this setup and config and will update with anything I find. I'd appreciate you replying with what you've found also. Another...

I've got an LDO V0.1 that is an absolutely rock solid printer. When the V0.2 came out I decided I wanted to upgrade because of some of the quality of life improvements. I've collected everything I need to upgrade the V0.1 to a V0.2r1. My problem is that my V0.1 is such a solid performer that...