Recent content by Dan_The_Printer_Man

I am using igus chainflex 4 wire cable with a mellow fly sb2040 bd. the cable has a green data line and a yellow data line connected to an xt30 connector. i need to know which line is low and which is high. i dont have a way of checking the continuity at this time to figure out which is which

I am not using any cable chains as i dont like them running canbus looking for a way to keep the A/B motor wiring harnesses encased in wire loom from falling onto build plate when the gantry is at beggining z height. i have a badge holder holding up the canbus cable uptop.

Yeah meanwell 5v psu would have been the way to go.

Watched your entire Voron 2.4 build

I am going to try octoeverywhere with klipper and mainsail