Register a free account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members!
Best advice I’ve gotten for slicers was to keep the settings close to generic values then your tune the printer , flow cal, bed level, retractions etc. once you do that you should have a printer that can do most prints without issues.
If prints are sticking so tight to pei sheet that it’s might destroy the surface, your first layer needs refining. I’ve never had abs stick that hard to abs unless my z offset was off.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.