Recent content by DarrylHadfield

No reason not to use existing power if you have it and have no need for an independent power supply, and are willing to risk the single point of failure. That said, there is sometimes need for an independent power supply, and some are unwilling to risk the SPOF. I for one prefer the separate...

Attached... Corners are clean, no elephant footing, extrusion is clean. Dims came out at 20.16 x 20.18 x 20.3. I'm pretty confident I can zero that better.

Thanks Sanity. It sounds like I'm probably okay; I'll drop it lower, just in case, to be more in the midpoint of where I was, vs. where the "lower end of the spectrum" 110hz is. Now for a little bit of additional tuning and then try a "for real" print.. calibration cube came out about as...

Okay, sorry for Zombie-ing the post, but... my A/B belts are at about 175hz. That seems... very loose. I note the docs (https://docs.vorondesign.com/tuning/secondary_printer_tuning.html#belt-tension) says: I put the belts on manually, used fingers to position before I locked them down, so...