Recent content by daschin

hi clear Z offzet after use G32,PROBE_CALIBRATE and bed_mesh_calibrate, then save the bed_mesh, lower the nozzle to bed and with a sheet of paper calibrate the Z offzet, save and test print.

If I had the 16 Tooth Pulley I changed them and it does not require changing the rotation_distance 40, adjust the max and min positions.

I have been doing the calibration from 0 starting with the initial value of rotation_distance:40 when doing a movement of 100mm the real movement is 80mm and in X is 81mm when using the formula of new_rotation_distance = previous_rotation_distance...

Hi I have a problem with the XY motors as I have configured the XY motor with rotation_distance: 32 but when verifying in X it makes the whole distance but when verifying the Y it does not do it for Y and for this to reach the whole distance I have to put it in rotation_distance: 30.6 the...

i reinstall everything and it was solved

in github config.cfg [probe] #-------------------------------------------------------------------- pin: !PG15 #-------------------------------------------------------------------- x_offset: 0 y_offset: 0 z_offset: 0 speed: 10 samples: 3 samples_result: median sample_retract_dist: 3.0...

this is what it would look like in reality

Hi, I have a problem with that is that when I send to print any STL to start this is not printed where it should and is wrong because it has the height map and ends up printing in the air but when you pause the print and start again is corrected and starts where it should be printed in the first...