VORON Design
Register a free account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members!
Recent content by DDB23456
-
D
Problem with extruder heating
Thank you! I changed the heater the thermistor and tried to bypass the canbus with no change in behavior.- DDB23456
- Post #3
- Forum: Voron Zero
-
D
Problem with extruder heating
Hi, I bought a A Siboor 0.2 Kit and since then I upgraded the printer to SKR Pico with raspberry pi 3B and Canbus from Bigtreetech EBB36, It all worked perfectly. Last week I made a stupid mistake and melted my printhead... Luckily, I had the needed spare parts so I assembled a new toolhead...- DDB23456
- Thread
- Replies: 3
- Forum: Voron Zero
-
D
Question Voron 0.2 cannot pull thread
Sorry. When I insert the filament into the printhead. The printhead cannot push the filament into the hotend, When I push manually the filament into the hot end, everything is working correctly. When I remove the hot end and try again, If the mechanism encounters a little resistance it stops...- DDB23456
- Post #3
- Forum: Voron Zero
-
D
Question Voron 0.2 cannot pull thread
Hi, I recently built a Siboor Voron 0.2 kit. Although I am new to the 3d printers, the build was smooth with almost no problems. The only problem I have is that the print head cannot seem to pull the PLA filament. I went to the instructions and everything is OK and in the appropriate...- DDB23456
- Thread
- Replies: 6
- Forum: Voron Zero