Recent content by Denesius

Sorry, no suggestions, just wanted to say good luck! I'm in a similar situation, and have been building a 500x500 custom printer for the past year and half. It works - that is to say it spits out molten filament and moves the extruder; as to function..... well, I'll post pictures and let...

If it's happening around the same area I'd start off by making sure there's no binding in the motion system. Not familiar with the spider board, but on my BTT board I had a similar issue where the current for one stepper was over 1.2amps, and the tmc driver would overheat. The driver has temp...

Have an LDO Nitehawk setup & it's running fine, and so far no drop-offs. Only issue is the attempt to get 'ACCELEROMETER_QUERY' returns 'Invalid adxl345 id (got 0 vs e5)'. Digging in Klipper reveals this is either a miswiring or power issue to the ADXL345, but since it's integral to the...

I don't see the Pi4 having speed issues - mine runs 3 printers. On the other hand, perhaps you're getting into heat throttling issues, or (less likely) voltage dropoff.

New Nitehawk installer here (no help, worked first time, woohoo!! That's probably more a commentary on LDO's design than my abilities). But..... Only issue is I get a klipper error that Sensor 'temperature_sensor nh_temp' temperature 102.504 is out of range. Now I know my board is not that hot...