Recent content by Dibbler

I am in the process of trying to figure this out too and so far it looks like: Legs, Power inlet, skirts and display mount Electronic mounts 3010 fan mount to cool the electronics Remove 5v converter if moving using skr pico vs skr e3 Whole new toolhead and xmount. Front Idlers (if you want...

I like what was done with the 0.2 manual. I will be gifting my V0.1 to my son when he graduates or I finish my current V0.12.. The V0.2 release is putting me a bit behind schedule :) I just learned from the above comment that the printed parts and where they are used is in a separate...

I would probably swap the "magnet application" step on page 90 until just after install and tighten the M3x40 BHCS with locknuts (page 93). If you do the magnet last you don't need to put holes in the magnet sheet?