Recent content by DmitryTverskoy

The RGB output on the board is organized through FAN connectors. But I only need one signal pin, I will take power from the additional power supply. Or do I not understand something? It is easier then to transfer the head to a CAN connection, thus freeing the control pin for the RGBW on the board

Thank you very much for the advice! I have TAP installed, it doesn't take the right pin?

Hello! Can't figure out how I can connect rgbw tape case lighting to my Fysetc spider 2.3? I ordered the ws2812b 5v 3pin tape. I already have Stealthburner installed with my own neopixel and the pin is PD3 busy. I can't understand where to connect the tape, please help me 🙏🏻

I managed to solve all three problems. It was about the voltage jumpers and the Voron Tap installed. For hotend fan and model blowing fan, the voltage was set at 12 volts instead of 24v. I also set a voltage of 5v for Voron Tap (it was 24 volts). I'm very happy that nothing burned while I used a...

More questions regarding the work of voron 2.4 1. When the printer is turned on, a constant small sound is heard from the hotend fan. The squeak frequency changes slightly at the time of changing the color of the backlight of the printing head, or if you manually rotate the fan; 2. When you turn...

the displacements were already on the first layers, there should have been no overheating yet.

With this setup, Klipper began to reboot when printing without even finishing the first layer ( Commented "stealthcop_threshold" and everything worked. Noise from motors with printer doors closed does not bother.

In fact, the noise of the motors does not bother me (although in noisy mode I have not heard them yet). But yes, errors could occur due to mode switching. I will take your advice and try different modes for the test. Are the run_current parameters set correctly for my engines (0.9 for XY, 0.7...

Does this rest on the capabilities of Spider 2.3 or Stepperonline?

Еще меня интересует, начинают ли при нагреве станины немного вращаться вентиляторы печатающей головки. И даже если обдув модели установлен на 0%, вентилятор обдува модели все равно работает во время работы принтера.

Hello all! I recently in 3d print, and immediately fell in love with Voron 2.4 Ordered it from China from seller Siboor. Included I received Stepperonline 17hs19-2004s1, Stealthburner, Voron TAP motors, Opi3lts and Spider 2.3 boards Despite my small experience, I managed to successfully assemble...