Recent content by Driden - LSLabs.co.uk

thats either your steppers skipping steps or the pulley not being attached.

When i had this it was due to the high infill width which many people use. I think the default on ellis's profile is 180%, which is great as it reduces the total print time by doing more infill per pass. however it depends on the nozzle you are using. I had swapped to a tungsten carbide nozzle...

I ground my frames. You scrape some of the anodised coating off and can attach that way. As your frame is connected to an unanodised section via the fasteners on each corner they should all be connected.

mainly for the full functionality for WLED which you cant really get from just klipper and a data pin. and depending how many led's you want to run the data pin may not be able to provide enough power.

If you want LED lighting you can always use a Cerebro for full WLED

My got to list is now GE5C Mod Ramalama Idlers Pin Mod Purge Bucket Unklicky 270 degree removable front doors magnetic fixed side panels Nevermore and i used to really like the decontaminator purge bucket up until i just saw the bedpan in the post above.

I had a nice thick piece of acrylic but it warped over time anyway. +1 for bed supports and top clips. Clamps it in place nicely and no more warping