VORON Design

Register a free account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members!

Recent content by fargonaz

  1. F

    Question Over extruding in some areas

    What does the bed side look like. There might be a bubble where it didn't adhere, which would be a mesh/1st layer problem.
  2. F

    Question Over extruding in some areas

    A picture would help.
  3. F

    Two Huvud questions

    The standard pull-up should work for the 104GT which is 4700, it's not necessary to specify this normally. Ya, crimping... You'll get real good at it.
  4. F

    Two Huvud questions

    Config?
  5. F

    Mainsail und Makerbase MKS PI Board

    Ya, I've had that problem also. I just soft linked (from the command line: ln -s <directory with your configuration files are really located> <directory where the application is looking for them> In your case the config files are probably located in /home/pi/klipper_config. If there is already...
  6. F

    Mainsail und Makerbase MKS PI Board

    Ssh in to the klipper device and issue those commands; one at a time.
  7. F

    Mainsail und Makerbase MKS PI Board

    Possible problems with USB cable? Can you post the output of 'dmesg | grep usb' and 'lsusb' ? These may need to be run as root.
  8. F

    Single source of truth?

    People like to talk about their printer. There are ZERO things you can do to prevent duplicates. There's a well known saying: You can lead a horse...
Top