What's new
VORON Design

Register a free account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members!

Recent content by Fogl

  1. Fogl

    Question Filament battles - What is you experience with polymaker ABS

    Polymaker PolyLite ASA nozzle temperature should be between 240C and 260C according to their datasheet. IMHO 230C is not hot enough to get a good layer adhesion.
  2. Fogl

    Question Filament battles - What is you experience with polymaker ABS

    My take on Polymaker ASA; Positives: Well, ASA is a great material to begin with High dimensional stability, weather resistant, temperature resistant Great diameter consistency Great for structural parts Negatives: The colors could be a bit washed out, especially black is kind of very dark...
  3. Fogl

    Parts detaching, most prints fail. What am I doing wrong?

    Could you, please, elaborate on your experience with acetone and powder-coated PEI? PEI (Ultem) simply does not react with acetone at all (https://www.astisensor.com/ultem.pdf) so I'm curious, where are the "poor results" coming from.
  4. Fogl

    Parts detaching, most prints fail. What am I doing wrong?

    I just went through exactly the same issue. New printer from LDO kit. It is very likely that new build plates have a coat of sealant of some sort, possibly to protect the silk-screened LDO logo in the corner. I'd suggest doing this: Take a new Scotch Brite and rub the build plate with soap and...
See more
Top