VORON Design
Register a free account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members!
Recent content by fursphere
-
F
Issue with printing with PLA (Stealthburner)
More CFM is the answer. 5015 blowers have a wide range of CFM. My PLA prints were looking bad with a cheaper Winsin 5015 blower, that per spec was around 3 CFM (probably lower). I upgraded to a Berserker 5015 from West3D that's rated at 6 CFM and PLA prints are significantly better. (I'm...- fursphere
- Post #11
- Forum: Voron V2.X
-
F
Orbiter 2 Clockwork 2 Mods?
This works with the EBB36 CAN Bus board. https://www.printables.com/model/345237-voron-stealthburner-orbiter-v20 You may need to review the remixes to get more fan clearance. I have built this one and the clearances seem fine. There is also this one that I haven't tried yet...