Recent content by gkuney

You were correct, I was using the old guide! I have gotten it into "RP2 Boot" now, which is what it says in the new version of the guide. I am now running into some other issues flashing the board but if I can not figure that out on my own I will make a new thread. Thank you very much, it was a...

Thanks for your reply! I determined that it was not entering DFU mode because the red light was not turning on and the lsusb command did not say "in DFU mode" as in the guide. Is that not correct?

Hello, I am using a Manta M8P with a CB1 as my mainboard and processor and an SB2209 RP2040 via Canbus. I have followed all the steps in the manual as well as many troubleshooting steps but I can not get the SB2209 into DFU mode for the life of me! I am in desperate need of help. I am...