Recent content by gochisar

I m working on load cell based bed levelling and homing sensors. HX711 and load cell may handle its. Many personal developers are innovating. We can find most different works on github. The same situation exists among klipper developers.There are wonderful improvements. The fact that it is not...

The biggest obstacle to printing speed is that plastic cannot be melted quickly. Instead of the traditional approach of bringing the nozzle to the desired temperature and continuing to print, the method is to calculate the amount of plastic to be consumed in the next second and give the...

The most important feature of open source development communities is that they develop with new ideas. Communities that aim to make money generally tend to stick to a single idea. Different ideas mean development. "to boldly go where no one has gone before" Gems to be discovered within...

Filament manufacturers do not produce full circular filaments. Filaments are generally ellipsoidal in shape. Two laser measuring devices measure the filament from two directions. If the filament cross section volume is low, the winder is slowed down, and if the filament volume is large, the...

I reviewed the 600x600 model. I wasn't very fond of the 2.4 model. Long PTFE tube causes many problems. It's actually annoying that when I have to print TPU, the prints are always interrupted. also, with two different print heads I will be able to use another filament along with HIPS...

Lead screws have a high gear ratio. Z movement will be smooth with low acceleration and low power. On the other hand, the flying gantry system in the 2.4 model has 4 extra stepper motor that require more processor calculations. I plan to change the extruder and nozzle system to double heads in...

@WhiteWulfe The documentation may need minor touches. It might be easier to figure out which part I need. STL name or link on github.

Excessive extrusion may cause lifting on the wall. Increase the extrusion volume for the first layer. decrease for other layers.

I have creality K1. K1 is trident replica. It moves the table with a single motor and belt system. I am planning to build a large area printer. I'm thinking 500x500 Trident. It is possible with a single stepper. Printing can be done with adaptive z height. I also have an idea to eliminate the z...