Recent content by Ho-whizzle

Hello again. I dont know what happened but all of sudden the klicky probe docks back into the holder about 1.5 - 2mm shorter than the original attaching position causing the probe to drop off 100% of the time when docking back the probe after homing Z. I have tried varies Y postion for the...

Hello again. I dont know what happened but all of sudden the voron tap probe docks back into the holder about 1.5 - 2mm shorter than the original attaching position causing the probe to drop off 100% of the time when docking back the probe after homing Z. I have tried varies Y postion for the...

Oh i didnt know about the print_end dupicate! thanks, If I want to park the tool head 30mm X and Y further from the max axis, what should I put in and where I put?

Hello, I hope you’re all doing well. I’m trying to fine-tune my Micron Plus so that when I pause or end a print, the tool moves to a desired position rather than its default position in the top-right corner, which causes it to crash into the umbilical cord and disconnect the cable behind the...

Hi all, I am stuck. I have installed KAMP with no issues so far but when I start a print it will not go to attach the probe to start the bed mesh. Please help

It seems that LDO is aware of the issue and its probably relating to the umbilical cable on the toolside as they has issued a section on their wesbite explaining the different kind of variant and later they will release a fully overmolded cable. This sucks because it says it will be available at...

Hi all, I have trouble etruding filament and i took apart the stealburner and notcied that the stepper is not turning. I have attach a link to the videos. Does this looks like I need to replace the stepper motor? If I do need to replace it, should I switch to a Dragon Burner and move to the...

hello, I am not stranger to Voron nor Klipper but this is the first time I am building Formbot Micron+ which is based on a V2.4 (I have built a trdient) and is using the BTT Manta M8P with CB1 board which is giving a lot of headaches as my weakness is software and coding. I have spent days...

Thank you, i think you're right.

Hello, I have a problem simialr to other in the forum commnity about ADC out of range but I am unable to fix it so I hope to get some help. The MCU in the title is the LDO Nighthawk SB and I have recently build klipper and mainsail from scratch I found a few bugs I couldnt fix so I started...

thank you! i will check it out

apologies for the spam but I noticed that end of printing the nozzle and heat bed does NOT cool down. question 5 how do i shut down the nozzle and heat bed after printing?

hello and apologies for the silly question but it has been a while since I changed klipper so i am rusty. I have erased and flashed a new klipper from scratch and every is good except the strange start up sequence when it start a print. The current sequenceis as follows PLA: - Heats bed to 60...

config file attached

hello and apologies for the silly question but it has been a while since I changed klipper so i am rusty. I have erased and flashed a new klipper from scratch and every is good except the strange start up sequence when it start a print. The current suequence is as follows PLA: - Heats bed to 60...