Recent content by HTMOTS

Tnx on your reply :) Do you know any limitations with those extruders? I so some data on Orbiter v2 like: Acceleration: 10000 mm/s2 * • Normal motor operating temperature: 60-75°C * The extruder itself without filament can handle acceleration up to 25000mm/s2. Adding weight of the filament it...

Hi guys. Im researching upgrades for my stock voron 2.4r2 350 (klickyng with hartk single pcb and RapidoHF) and im a little bit overwhelmed with information so if you can help me? 1. I know that i would like to upgrade to Mantis toolhead because of better cooling for PLA (If there is a better...

On Sunlu white pla i get around 12 mm3/s and on Azurefilm TPU i cant get 9 mm3/s both of them on max recomended temp from the manufacturer. Asa is more of 15 mm/s but on high 260C

Hi guys, im having a problem with temperature falling down by 1.5 C when extruding (via mainsail extrude command). Was trying to figure out vol flow on my rapido hf hotend and i cant get advertised 24 mm3/s, its way lower depending on the filament i use (pla, asa and tpu). Then i noticed the...