Recent content by Jacques

I did mismatch the gantry corners 😱 now with a BTT H2 V2s Revo extruder mounted on a ChaoticLab TAP and the following config it works fine ! [quad_gantry_level] gantry_corners: -50, -20 # left / front 400, 370 # right / rear

I am using a Voron 2.4 for more than a year and recentrly I tried to use the BTT-EDDY for bed mesh only, probing with Voron-TAP. Apart from rapid bed mesh wich is nice I did not found the EDDY very satisfactory so I reverted to using the Voron TAP only, but now I get stange behavior during QGL...

Yes step files are a bit easier to modify but still made of "large" polygons not easy to handle in rather complicated design as the Stealthburner front plate. A vector based design would be less complicated, if not easier, to modify in Solidworks, Fusion3360 or whatever.

I understand but STEP files are a pain to modify. I don't mind which CAD package to use but recreating the Stealhburner part from scratch doesn't make sense since these must exist already.

I would like to make small changes (support for a BIQU Smart Filament Sensor for instance) to the Stealthburner burner, are there F3D source files available for mods ?