Recent content by Jekle

Thought the belts were already on the tighter side, but turns out, giving the belts another turn to tension them fixed it!

Hi all, Fairly new here, just bluilt my first printer, a Voron 2.4 (pro) from a Formbot kit. So far, everything seems to be working well, except for one thing: whenever I try to print, I consistently get these shifts, from the looks of it it even seems to be within the same layer. In the photos...

Yes! That did the trick! Thank you so much! Going from red to orange now! More stuff to dive into/fix, but we're getting there!

It then comes back with "Unknown pin chip name 'host'"

Switched them up, now it's complaining about gpio79, which is mentioned for [fan_generic soc-fan] in my .cfg. Seems to be a mistake in the sample file, probably should be gpio26 looking at the board. It then throws up this: I've also tried "pin: host:gpio26", "pin: CB1:gpio26", with similar...

Hi all I've built myself a Format 2.4, with a Manta M8P + CB1 + SB2209 (RP2040). After spending an entire day getting the CAN to work, I finally got that up and running. I'm working on mixing and matching my config file (I've named it mainconfig.cfg) but now I'm running into this issue. I've...