Recent content by josh284

Hi RYGRR, I have finally found a solution to my problem. The solution came about when i found that i could tape a small shim to my bed and tell the QGL to test the location at that new point that was made artificially higher and then i was able to print again as per normal. What i found was...

Hi @Sanity Agathion, I was able to find a way to get the images, scp wasn't working for me but i downloaded the Cyberduck program and it made it much easier. I have looked at these charts and they all look like the printers belts are tight and the klicky probe is reliable. Am i missing...

Hi Sanity, I have a single MGN12 rail on the gantry. I have attached a mesh from when i had heat soaked the bed for over an hour. I have also added the data from that script, i couldn't work out how to get the charts but the data looks like the sensor is ok. Is that correct? Thanks in...

Hi All I have been printing with my Voron 2.4 for nearly a year and have gone through many kilo's of filament without any major issues then recently the first layer changed to have a 'tilt' from being too high on the back left corner to dragging the nozzle on the PEI sheet on the front right...