VORON Design

Register a free account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members!

Recent content by Joshuamcvey

  1. J

    LDO Voron 2.4 Build with All Metal Parts

    Whats she look like again?
  2. J

    LDO Voron 2.4 Build with All Metal Parts

    is this build finished?
  3. J

    LDO Leviathan Control Board Information

    Klipper on the toolhead is out of date...maybe
  4. J

    Ldo leviathan

    It opens up 48v drivers, It really opens up under the printer ..cleans up the whole install It has just been a dream to work with, been rock solid...the octo was too but I am just more happy with this setup
  5. J

    What makes a Voron a Voron?

    I wanna make a shirt that reads "Chances are its a Voron"
  6. J

    Ldo leviathan

    Just want to report that this board is amazing Have about 500 hrs on it Really really prefer this over an octopus
  7. J

    LDO Leviathan Control Board Information

    What are these?
  8. J

    LDO Leviathan Control Board Information

    I was going to say that mine been pretty flawless so far but I'm on a brand new Linneo harness,nitehawk PCB just showed up. When this harness goes I'll switch over to the Nitehawk. Im running a 350 w 48v psu and 200w 24v psu I need to start pushing the speeds I think
  9. J

    LDO Leviathan Control Board Information

    I screwed up and got the 350watt 48v psu
  10. J

    LDO Leviathan Control Board Information

    How did your install with this MCU go?
  11. J

    Ldo leviathan

    Has anyone started using this board on their 2.4 yet? Are the fans 3 pin jst? What has your experience been? Are you happy with it? I am upgrading my 2.4 which has just over 3400 hours on it anyone have any tips on this board?
  12. J

    Anyone else using a Super PINDA?

    I've been hunting everywhere for how to do this This pins are throwing me off
  13. J

    Anyone else using a Super PINDA?

    whats the pin out for this?
  14. J

    New build and tap

    Yeah... I'm using the v3 2 piece hartke version and pulling 5v off the 5v header...... Its all so confusing... I thought the mechanical part was going to be the most difficult, it was actually fun.... The wiring and firmware got me shook up.
  15. J

    New build and tap

    Im reading your experience on a separate post Clauder so the short of it is...you got TAP working on the v4 two piece Pcb from hartke?
Top