Register a free account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members!
I have a Revo, Rapido and had a Dragon. Of those 3 the Dragon was hands down the worst, so I'm not going to bother talking about it. But the Rapido perform exactly like the Revo. There are claims the Revo has higher quality and I initially found this to be true. Then I realised it was...
Pretty much all the info you need is here: https://github.com/samwiseg0/Voron-Documentation/blob/add-btt-smart-sensor/community/howto/samwiseg0/btt_smart_filament_sensor.md
As was said in the video, the sloppiness is seen when the chamber heats up. So an Aluminium skeleton could very well perform better.
Tap identified the issue. It wasn't the root cause. Meaning carbon fibre gantries are a bad idea, based on the data.
Folks who tested Tap had significantly reduced stiffness in the gantry with a carbon fibre gantry and it is moving around all over
I'd be more interested in how the hollowed out aluminium kind compares, and if it has the same problems.
It will likely have some issues as you are sacrificing...
Unless I'm mistaken, at the time of this writing, the difference between the profiles is the limit configured for "Volumetric Speed" in Print Settings.
They are otherwise identical, far as I can tell.
I actually appreciate that it is a really good starting off point profile for decent speed with...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.