Recent content by Kwadratowicz

I've managed to make it print, but it is not finished, cause I've forgot that I need to flash display to make it work. and fans for part cooling had wires messed up, needed to change the polarity of connector. After testing kinematics I've needed to change bolt on front of the heating plate...

After testing the kinematics if everything works fine I've managed to close front. I've added some two thingy glue to heatbed just to be sure. The bed is a little to low, so I need to add washers to make that spring is properly squeezed. Edit: I think that only front is screwed properly, rest of...

It's working, but the psu coil whine is driving me crazy.

I've tensioned the belts to 115 Hz cause it was 110 on both belts, and after securing nuts on tensioners it has made 115 Hz. And I've made it to the wire mess :D, Today I'm installing klipper and I hope I will test if it works. I've made mistake, and added to bed 40mm screws cause of the manual...

Update I've made it to belts :D. But some dimensions where smaller than voron guide has said, like height of bearing stack that should have 19mm had 18.53mm, I don't know if it will be a problem later, but for now the build is working quite well, linear rails works without problems after...

That lubricant says on package that is good up to 100C :) And officially I hate formbot kirigami bed support -.- It is a little crooked and when fully screwed in it is making the rails to work with resistance -.- And I don't know if it was my fault or from the supplier, but it is really easy to...

Hello there good People, I've finally started working on voron 0.2 r1 kit from formbot. everything is from formbot even 3d printed parts. Funny thing m2 bolts are not 1.5 hex but something between 1.5 and 2. (I've tested with different stuff and finally some torx was great for it, and for now...

Yep I've got my hands on 3d printed parts and there is phateus high flow :). But custom inspection has looked inside of the package, cause the cutouts have different parts in them, and some are even unpopulated, and rest is just shoved inside in the biggest cutout.

I've bought formbot kit with 3d printed parts and hf dragon, but on site they said that dragon hf and 3d printed parts are shipped from China, so I will see tomorrow what is inside the package from china :). Cause in the main cartboard I've got the same hot end as You, and I hope that I've got...

Hello I've bought kit for voron 0.2 r1 from formbot and in it there is TZ v6 2.0. The wires are stiff as... I'm waiting for China parts to come with dragon hf.