What's new
VORON Design

Register a free account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members!

Recent content by magnusjager

  1. M

    Solved Tap Wiring with LDO Afterburner PCB

    New tap and still registers no difference. I tried running a jumper to the signal to eliminate any problems there. Unplugged still reads as triggered on endstop z and probe... There's 24 v to the pcb as well. Even tried moving over 2 slots and setting to PG13 in probe. No idea where to go...
  2. M

    Solved Tap Wiring with LDO Afterburner PCB

    Been chasing a similar issue on one that was working then had several other issues at the same time. After new one piece pcb, fans and leds (LEDS still don't tun on). I have most things working, but the optotab 2.4.1 after new pcb the leds there are brighter and register changes, but it never...
  3. M

    Klipper reports: SHUTDOWN MCU 'mcu' shutdown: Timer too close on hard print

    Also found this https://klipper.discourse.group/t/debian-11-bullseye-udev-bug-no-board-or-serial-found/10711 udev: Installed: 247.3-7+deb11u2 Candidate: 247.3-7+deb11u2 Version table: *** 247.3-7+deb11u2 500 500 http://deb.debian.org/debian bullseye/main arm64 Packages 100...
  4. M

    Klipper reports: SHUTDOWN MCU 'mcu' shutdown: Timer too close on hard print

    was already masked... pi@trident:~ $ systemctl status ModemManager.service ● ModemManager.service Loaded: masked (Reason: Unit ModemManager.service is masked.) Active: inactive (dead) pi@trident:~ $ I also tipped it and checked the usp cord route. It might be the cord that comes with...
  5. M

    Klipper reports: SHUTDOWN MCU 'mcu' shutdown: Timer too close on hard print

    Thanks since the "Resource temporarily unavailable" may have began with me hitting the "update" buttons on my machine that would likely coincide with the timing of these new messages. I'm also waiting to see if the print succeeds or fails again. I have resliced the parts from the fail point...
  6. M

    Klipper reports: SHUTDOWN MCU 'mcu' shutdown: Timer too close on hard print

    Starting the remaining portion of the print. Getting some of these in Syslog. The syslog and daemon file was huge before i did a rotate on it. Feb 28 21:57:50 trident klipper_mcu[395]: Got error -1 in write: (11)Resource temporarily unavailable Feb 28 21:57:55 trident klipper_mcu[395]: Got...
  7. M

    Klipper reports: SHUTDOWN MCU 'mcu' shutdown: Timer too close on hard print

    I just got my voron trident 300 used. Few great prints. Doing a very challenging one and twide have gotten Klipper reports: SHUTDOWN MCU 'mcu' shutdown: Timer too close I slowed the speed factor down to 70% after the last one happened only an hour or so. This one was about 15hrs in. I've...
See more
Top