VORON Design
Register a free account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members!
Recent content by MakkeLeon
-
M
Hello I am new here and need some help.
It is preinstalled I didn't do anything to the software. But the serial is OK I checked it. So it is flashed.- MakkeLeon
- Post #5
- Forum: Voron V2.X
-
M
Hello I am new here and need some help.
It is as you say. If i turn on the printer it start heating immediately till it get to the maxtemp and then it gifs a mcu error and shutdown. I have to disconnect the wires to turn the hot end off. The printer came with a canbus.- MakkeLeon
- Post #3
- Forum: Voron V2.X
-
M
Hello I am new here and need some help.
Hello, I did build a voron 2.4 but when I started it up the hot end starts heating and goes on till it hit the max and then it turns off. another problem is the homing the x as goes well but the y as goes forwards so it never goes go to the end stop in the back. And if I try to move the z as it...- MakkeLeon
- Thread
- Replies: 4
- Forum: Voron V2.X