Recent content by Marine6680

Managed to get some help on the Tridex Discord.

Hello, I was hoping someone here could assist with the homing routine with Tridex. Need to edit some of the configs so that it homes properly. After a toolhead type change from the Stealthburner to the Rapidburner toolhead, the homing has changed. T1 now homes to the left side of the printer...

Swapped to TAP and that is working well. I am not sure if the magnets are actually doing anything though. I do not feel resistance when lifting the toolhead. Had some inconsistent extrusion. It would be fine and then under extrude for a bit and then be fine again. It was consistent as well...

Well, I believe I am giving up on the PZ Probe. While I do not have all of the panels in place, I did add some foam fill into the channels of several of the extrusions to reduce some vibrations. After much experimentation, I settled on a probe movement speed of 5mm/s and a stepper power...

I am in the process of building a Tridex. While I am familiar enough with klipper that I can follow guides and even figure out some things on my own, and also Linux console command work, enough that I can follow guides without issues... I am in no means proficient. I am great with mechanical...