Recent content by martin77

The EBB board is inside the stealthburner, as such, within the case. So the stepper does not seem to be the problem on my side, as the chamber is closed and heated. Most likely there may be several reasons for this "behaviour", but on my setup it seems to be something inside the electronic bay...

I am experiencing the same issue, so I'm reading this topic (and others) regarding that issue. When I set up my Voron 2.4 with EBB SB2209 CAN V1.0 (RP2040), everything worked fine. I then placed my printer down to the cellar, and then the issue appeared. Not being able to print items which last...

Well, I understood that like you, that I need a U2C module to use CAN bus. But I asked myself: Why? According to this "small" board specifically designed for the BTT Pi is not connected to these CAN pins on the BTT Pi: It's connected to some part on the 40-pin-GPIO header. So...is there any...

Hi all, my current setup on Voron 2.4 R2 is without CAN: BTT Pi 1.2, Oktopus 1.1 and Stealthburner. Now I want to switch to CAN (and not wait until a cable gets broken). The documented way is to use the Oktopus board as CAN bridge - I know. But: As the BTT Pi already has CAN Pins I am wondering...