Recent content by maz

Klipper's latest update was a "major" version including changes to the firmware, so you will need to re-flash all your MCU's per the message you are seeing. Simply following your EBB guide will fix the EBB, Your MCU will be your mainboard, depending on what this is will determine on a suitable...

So I'll try to address a few things :) 1. Printed Parts / Sourcing Info - There is a market place on the Voron Discord for exactly this purpose - #printed_part_thunderdome - you'll need to sign up for a role, but this may get you a bite. - #brexited-gb is the regional channel, you'll find a...

Roughly in line with my findings (reworded my post from #voron_electronics on discord) Initial peak is around 1000W for a 750W bed and Rapido both at 100% duty cycle. This quickly drops to around 350-400W and gradually declines to 150-260W in the following 20minutes Now my graph covers the...

The screws loosening sounds like stresses in the print, which I can honestly say haven't occured on my beta NG which did about 800ish hours combined at close to 70C including 36 hours of continuous probe calibrate dock undock cycles during the testing phase. It would probably still be in the...

Still using markdown, via vscode or typora. If I need diagrams I use draw.io or inkscape