Recent content by Mittnz

If you don't buy a kit, there are a few things that you CAN buy "kits" for, that make sourcing way easier. For example, I bought the Hardware Kit from Printed Solid, and it was so much more convenient than it would have been to source all of that hardware. Especially because you have to buy...

Yeah, I put the jumpers here: (shown in my photo of the board, also) I did this according to the Fysetc Spider v2.3 for Trident wiring guide.

Yes, I have the Omron probe (same one from the Voron Trident BOM), hooked up to an LDO Stealthburner toolhead board (the two-piece board, which includes the bat85 diode). I then used the LDO wiring harness (from West3D) to run back to the LDO breakout board, and from there, wired each...

So... I'm currently building a Trident. The physical build is done, wiring is done, was just doing the software config. I just spent 2 days trying to figure out how to get my Pi to see the FYSETC Spider v2.3 via USB (tried UART) too. Finally resolved that by building the "no bootloader"...