Recent content by mjonuschat

Your PRINT_START macro is looking for parameters with the name EXTRUDER_TEMP and BED_TEMP, but your slicer is using EXTRUDER and BED as parameter names.

To answer the original question: These ports don’t have pins because those are two always-on fan ports, you can’t control them.

Why do you want to got from Stealthburner to Afterburner? Afterburner doesn’t work with tap to begin with. If you meant Stealthburner + Orbiter 2.0 + Tap then this mod works great: https://github.com/elcrni/Voron-Mods/tree/main/Orbiter_2.0_SB_CW2_Enclosed

I'm using a Logitech C930 (not the C920) in the Trident. Field of view is pretty ok, I'm maybe missing an inch or so in the back, remixing the mount to change the mounting angle a bit should be able to fix that. In general I find that the fixed focus gives me better results than autofocus as...

The usual culprit is the bridge flow ratio which gets mangled readI guess the SuperSlicer profile. 85% in SuperSlicer turn into 8500% in PrusaSlicer as that uses fractions (0-1) for flow rate. You can also check out https://github.com/mjonuschat/PrusaSlicer-Profiles for PrusaSlicer profiles...

1) Color selection is decent for ABS and slowly getting there form ASA. All colors seem a little bit less vibrant / more muted than KVP 2) once it’s tuned prints well and consistent, initially had a decent amount of stringing with my CHT nozzle, even after drying 3) Seems to like hot nozzle...

1) So far it's been great, experienced none of the issues reported on Discord so far (all spools bought after Sept 2022) 2) Excellent color selection - especially the fluorescent and stellar colors are great 3) So far it's been super reliable, between spools and colors. 260°C nozzle, 115°C bed...